| Our Objective: |
| Enhanced Customer Service is a prime objective for everyone at Evans Industries. It is recognized that our customer support is the corner stone to our success. |
|
|
| |
|
|
249 Boston Street, Topsfield, MA 01983
Phone: 978-887-8561 Fax: 978-887-3850 E-Mail: wrobie@evansindustries.com
Established in 1966
|
| Products |
|
 |
 |
 |
| Machined complete with two operations utilizing our DMG Evolution 70, 5 Axis Milling Center. Part is approximately 14" X 9" X 5". |
Machined complete with three operations utilizing our Puma 300M CNC Lathe/Miller & DMG Evolution 70, 5 Axis Milling Center. |
Machined complete with three operations utilizing our DMG Evolution 70, 5 Axis Milling Center. Part is approximately 12" square. |
 |
 |
 |
| These two plates, machined with our new Kitamura Bridge-10, are over 8 feet wide. The plates where part of an Evans Industries sub-assembly used in the power generation industry. |
This chamber, machined on our 5-axis DMU 70 Evo, has been assembled with rows of magnets along the inside diameter. |
A vacuum chamber after finish machining that is ready for polishing and test. This chamber can be seen being machined on our 5-Axis DMG 160U in the Shop Tour section, under Machining. |
 |
 |
| These are examples of three different blades that Evans Industries produces for the printing industry. The blades are used on printing presses to control the release of ink. |
This is the bottom blade shown in the left picture. You can see the .006 wide slots that were laser cut into the blade. |
|
|
